檢查井模具生產加工 污水檢查井模具的使用方法

污水檢查井模具使用4mm-6mm鋼板經過定尺、裁剪、彎曲成形，使用50mm-80mm長的
勒筋作為加強筋固定，污水檢查井鋼模具分為內模三塊外模兩塊組合而成，方便工
人使用的時候拆卸，由于外層具有多道加強筋因此即便使用三至五年也不會發生變
形情況。
污水檢查井模具的使用方法都是先在模板上涂抹脫模劑、組裝模具、放置鋼筋、澆
灌混凝土、振搗氣泡、凝固、拆模等幾個步驟。檢查井鋼模板配套的配件有料帽、
定位稍、連接孔、上蓋、底座、凹凸槽等等，這些產品都是根據施工要求來使用的
。注漿后的檢查井鋼模板內部需要長時間振搗，將氣泡全部排出，不然很容易讓混
凝土檢查井出現蜂窩麻面等問題，影響工程建設。
the sewage inspection well mold is made of 4mm-6mm steel plate, which is
scaled, cut and bent, and fixed with 50mm-80mm long rib as stiffener. the
sewage inspection well steel mold is divided into three internal molds
and two external molds, which is convenient for workers to disassemble
when using. because the outer layer has multiple stiffeners, it will not
deform even if it is used for three to five years.
the use method of
sewage inspection well mould is to apply release agent on the formwork,
assemble the mould, place reinforcement, pour concrete, vibrate bubbles,
solidify and remove the formwork. the accessories for the steel formwork
of the inspection well include material cap, positioning point,
connecting hole, upper cover, base, concave convex groove, etc. these
products are used according to the construction requirements. the steel
formwork of the inspection well after grouting needs to be vibrated for a
long time to discharge all the bubbles, otherwise it is easy to cause
problems such as honeycomb and pitted surface in the concrete inspection
well, affecting the project construction.